Hydrant Flushing: March 25-26th

Hydrant flushing is necessary to test the hydrants to make sure adequate flow and pressure is available. Flushing is also done to remove sediment from the pipes in order to maintain water clarity and quality in the distribution pipes.

Your water is safe to drink. Occasionally, water becomes discolored after hydrant flushing. If this happens, run your cold water tap for a few minutes until the water clears. If it doesn’t clear the first time, wait a few minutes and run the water again. You should avoid washing clothes until the water clears. If your clothes get stained don’t put them in the dryer. Rewash them once the water clears.  Please call City Hall with any questions or concerns at 503-667-6211

Lower System

 

 

Upper System

 

 

COMMON WATER QUALITY CONCERNS

Rusty Water

As described in the previous section, fire hydrants are periodically opened to flush water mains in the system. Additionally, Fire and Public Works Department personnel routinely use hydrants to make assessments as to whether adequate pressure and flow are available to satisfy normal system demands as well as the increased demand required in the event of a fire. These actions, as well as some construction activities, may result in brief periods during which you may observe moderate discoloration in your tap water.

In addition to following the suggestions outlined above, the City is involved in an aggressive water main cleaning and lining program, designed to reduce the occurrence of this problem in the future.

Cloudy / Milky Water

In the late fall and winter months the water that enters your homes can be quite cold. When this cold water enters your home plumbing, it is exposed to significantly warmer temperatures. This causes dissolved oxygen, that can reach significantly higher levels in colder water than in warmer water, to escape in the form of “micro-bubbles” that can give water a cloudy appearance. If a glass of this water is allowed to sit for a short period of time the cloudy effect will dissipate.

 White Particles in the Water

It has been determined that a number of hot water heaters manufactured between 1993 and 1997 may have defective cold-water supply dip-tubes. These tubes are designed to direct the cold water entering the heaters to the bottom, thereby forcing the previously heated water to the hot water outlet near the top of the tank. The defective dip tubes have been found to separate from the cold-water inlet and, over time, disintegrate into minute pieces resembling crumbled eggshells. This material can readily clog sink aerators and showerheads but is reported to be non-toxic.